7.
Hold the cable while pulling the tool so that it
strips off the cable jacket. The end of the cable
should now look like the figure below.
8.
Slide the connector body, wide end first, onto the
prepared cable until the edge of the cable’s foam
is flush with the bottom of the connector body
(inside its threaded end). The cable’s center
conductor should extend
1
⁄
16
" beyond the end of
the connector body.
54-0208-01
3.7
Installing the Receiver
9.
Slide the compression fitting up into the
connector body. Then place the cable with the
connector into the tool cavity. Be sure the cable’s
center conductor is straight and fits into the tool’s
center hole.
10. Squeeze the lever toward the tool until you feel it
“snap” as the fitting is forced into the connector,
making a weather-tight seal. A white indicator
will appear in the sight hole
(shown in the previous
figure)
when the seal is achieved.
The F-connector
is now ready for use!
Connector Body
Compression Fitting
Braid
Foam
Center Conductor
Sight Hole