c.
Place a rubber spacer onto the end of each
rubber mounting block.
3.
With the antenna centered on the vehicle’s roof
and resting on the four mounting blocks, mark
the eight mounting hole locations. To mark the
holes, you can use either a transfer punch or a
21
⁄
64
"
drill bit as shown below.
4.
Keeping the antenna level at all times, carefully
remove the antenna and mounting blocks from
the vehicle’s roof and set them aside in a safe
place.
5.
Using a
7
⁄
16
" drill bit, drill the eight mounting holes
in the vehicle’s roof. Be careful to drill through
just the metal roof, and not through the headliner
beneath it.
54-0208-01
2.12
TracVision A5 Installation Guide
Bracket
Plastic Spacer
Rubber Spacer
Mounting Block
Adding a Rubber Spacer to the Mounting Block (If Needed)
Marking the Mounting Holes Using a
21
⁄
64
" Bit
