NVR User
’
s Manual
16
3.1.6.3 Call Preset Points
Follow the steps to call preset points.
Click on a camera channel that equips pan/tilt/zoom function.
Select a preset point number from the Preset Point List.
Click on <
> to call the preset point. The selected camera will
automatically move to the preset position.
3.1.6.4 Set a Camera Tour Path
The NVR allows users to set Tour Path. Follow the steps to set tour paths.
Click on a camera channel that equips pan/tilt/zoom function.
Select a tour path number from the Tour Path list.
Click on < > to start recording the tour path.
Use the Direction Control Panel to pan/tilt the camera to set a tour path.
After setting, click on < > to save the position.
3.1.6.5 Run a Camera Tour Path
Follow the steps to run the camera tour path.
Click on a camera channel that a camera tour path is already set.
Select a Tour Path number from the Tour Path List.
Click on < >, and the camera will start touring as recorded.
Click on Direction Control Panel to end the camera tour.
3.1.7
Camera Image Setup
Users can configure the image settings of the selected IP camera. The image
settings include image adjustment, noise reduction, white balance, etc.
Users should first click the desired IP camera channel and then start the
setting. When users are adjusting image configuration, users can then watch
the channel grid to check the change of image setting. After setting, click
<Apply> to save the setting.
NOTE:
Some setting items may be unavailable for certain IP camera
models. Thus, those setting items will be grayed out and cannot be
accessed.
