4 Replacement Procedures
4.12 Cover assembly and Base assembly
4-46 [CONFIDENTIAL]
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the Cover assembly and Base assembly
To install the cover assembly and base assembly, follow the steps below and refer to Figure
4-22 to 4-26.
1.
Place the
cover assembly
on the
base assembly
and secure them with the following
screws
.
•
M2.5
×
8B FLAT HEAD screw
×
5
•
M2.5
×
12B
FLAT HEAD screw
×
3
2.
Turn up the
insulator
(LCD CONN INSULATOR) and connect the
LCD harness
to
the connector
CN5300
on the system board.
NOTE: Arrange the LCD harness under the guides.
When replacing the cover assembly with a new one, stick the insulator (LCD
CONN INSULATOR) to the system board in place.
When sticking the LCD CONN INSULATOR, set the cushion of the LCD CONN
INSULATOR on the connector of the LCD harness.
3.
Connect the
FS board FFC
and
camera harness
to the connector
CN9550
and
CN9540
on the system board.
LCD harness
Guide
Guide
Guide
Summary of Contents for Satellite Pro S500M Series
Page 286: ... CONFIDENTIAL Chapter 4 Replacement Procedures ...
Page 402: ... CONFIDENTIAL Appendices ...