4-10
User’s Manual
Operating Basics
Removing compact discs
To remove the disc, follow the steps below.
1. To pop the drawer partially open, press the eject button. Gently pull the
drawer out until it is fully opened.
2. The disc extends slightly over the sides of the drawer so you can grasp
it. Hold the it gently and lift it out.
Removing a disc
3. Push the centre of the drawer to close it. Press gently until it locks into
place.
Buttons
The CD/DVD button can be assigned special functions in the TOSHIBA
Controls Properties.
CD/DVD play control buttons
In addition to the power button, the following four buttons control functions
of the optical disc drive and Digital Audio Data:
Do not press the eject button while the computer is accessing the disc
drive. Wait for the
optical disc
indicator to go out before you open the
drawer. Also, if the disc is spinning when you open it, wait for it to stop
before you remove it.
■
When the drawer pops open slightly, wait a moment to make sure the
disc has stopped spinning before pulling the drawer fully open.
■
Turn off the power before you use the eject hole. If the disc is spinning
when you open the drawer, it could fly off the spindlend cause injury.
Play/Pause
Starts or pauses play
Stop
Stops play
Next
Advances to the next track, chapter or data
Previous
Returns to the previous track, chapter or data
Summary of Contents for Satellite M40X-119
