127
1
2
2
3
3
Adjust cover
Wire fixing part
Panel stopper
Wire fixing part
Wire
S-shape bracket
Center panel
Bump
Hook
Opening
port side
Hanged side
Opening
port side
Hanged side
Push the center panel holders in until
they are level with the Frame cover
and fix them with the loosened screws.
Hang to the wire fixing part
from down side.
If hanging it from upside,
the bracket may come off when
opening/closing of the center panel.
Hook
(Condition that inserting into adjust cover shaft)
Center
panel
Wire
Frame cover
Center panel holders
No.
1
Part name
Center panel
(Continued)
Procedure
2. Attachment
1) Insert hook of the center panel into shaft
of the adjust cover. (2 positions at left
and right sides) Insert hook attached
with a panel stopper.
Note)
Be sure to attach a hook with panel stopper at
first. If attaching a hook without panel stopper
at first, the center panel cannot be attached.
2) Hang S-shape bracket of the wire to the
wire fixing part from down side.
Note)
If hanging it from upside, the bracket may come off
when opening/closing of the center panel.
The wire is provided to prevent falling of the
center panel. Be sure to attach it to the wire
fixing part.
Figure 2
Remarks
Figure 1
3) Turn the center panel slowly to
1
direction and then close it.
Figure 3
4) Under condition that opening port side
of the center panel closes, lift up the
bump at hanged side
2
and then slide
it to
3
hanged side to fix it.
Hold the positions near the hooks at
both sides of the center panel, and fix it
to the unit one by one.
5) Push the four center panel holders
inside and make them level with the
frame cover, and tighten the screws
which were loosened when detaching
the center cover. (Figure 4)
Figure 4
