Toshiba Magnia 3135R, User Manual

Page: 47 / 227

Getting Started
BIOS Setup
47
BIOS Setup
The server’s system setup can be changed using the BIOS Setup utility. You can make
changes to the BIOS Setup even if an operating system has not been installed on the
server. The system settings you enter are written in the CMOS and flash memory and
take effect when you restart the server. BIOS settings are used for reference during the
POST.
If the server hardware doesn’t support the values you enter, an appropriate error
message appears on the screen when the POST routine is complete. If this occurs,
change the setting using either the BIOS Setup Utility.
Turning Off the Server
The procedure for turning off the server depends on the operating system installed on
the server. Always perform a normal shutdown when turning off the server.
Performing a Normal Shutdown
Turn off the server using the following method:
1 Shut down the operating system. For instructions, refer to the user’s guide that came
with your operating system.
2 Press the Power button to shut down the system.
TECHNICAL NOTE: If the server is turned on through the Wake On LAN function
and turned off again before the Windows NT LAN driver is loaded, a startup fault
may occur the next time you attempt to start the server using the Wake On LAN
function. If this occurs, disconnect and then reconnect the power cable from the AC
outlet.