Setting Up Your Satellite Receiver
Page 2-15
Note: The HD receiver VIDEO output defaults to the Y, P
r
, and P
b
HD
connectors when first used. If you are not using an HDTV monitor, or prefer
to use the standard video outputs, try switching the outputs of the HD receiver
from HD to SD. Using the remote control, press the
button once, then
press the
button, followed by the
button. Pressing this sequence
of keys will switch the receiver between the High Definition (1080i) output
mode and the Standard Definition (480i) output mode. Following one or more
of this
sequence, your picture should appear.
POWER-ON Screen
As power is applied to the DST-3000 receiver for the
first time after being plugged in or after a power failure,
the
POWER-ON
screen, shown on the right, is
displayed. The screen will not appear each time you
press the
Power
button.
A panel will display an
Exit
and an
Installation
button.
Below that, a progress meter will display illuminated
boxes, which will progressively light up from left to
right as the system powers up.
Exit
Highlighting the
Exit
button on the screen and pressing
the
key on the remote control causes an exit from the
POWER-ON
screen and interrupts
the Guide data acquisition.
Installation
If the power is on, but the satellite dish antenna or local area antenna or cable system inputs are
not yet installed, highlighting the
Installation
button and pressing the
key on the remote
control will display the
INSTALLATION
screen. Read Chapter 4 for installation and testing
instructions.
If the satellite is properly pointed, the program guide is loaded when power is applied. You can
exit out of this start up process, but you would not load the current guide data. Allow time for this
program data to load.
Note: If your satellite dish is properly pointed and receiving a signal, this boot-
up process is necessary to completely load the Advanced Program Guide™
information. If you exit this screen before it is complete, or have yet to install
the satellite dish, this process will take place later. Loading Advanced Program
Guide™ data can take several minutes.
If you are using the HD receiver with only the terrestrial antenna or cable
signal, you can immediately exit this screen.
SAT
ACTION
INPUT
ACTION
INPUT
The POWER-ON screen
SELECT
SELECT
Summary of Contents for DST-3000
