Toshiba DST-3000, Owner'S Manual

Page: 28 / 98

Toshiba DST-3000 High Definition Digital Receiver
Page 2-10
4) Connect another set of standard audio/video cables to the back of the VCR using the
AUDIO and VIDEO output connectors. Connect the other end of this cable to another
group of unused input connectors on the back of the TV.
Note: There are possible variations to steps 3, and 4 above. For example, if
your TV or monitor has only one set of AUDIO/VIDEO input connectors, or if
you have an S-VHS VCR, you may choose the following connection variation:
Connect the AUDIO and VIDEO or S-VIDEO connectors of the HD receiver
only to the VCR. Then connect the VCR output connectors to the TV. In this
situation, you may need to turn on your VCR to pass HD receiver signals to
your TV.
5) Optional: If the TV does not have AUDIO/VIDEO input connectors, then connect one
end of a coaxial RF cable to the OUT TO TV connector on the back of the HD receiver.
Connect the other end of the coaxial RF cable to the antenna input connector on the back
of the VCR. Connect another coaxial RF cable to the antenna output connector on the
back of the VCR and connect the other end of this cable to the ANTENNA or VHF input
connector on the back of the TV. Set the CH3/CH4 switch on the HD receiver to the
channel not used in your area. It is this channel you will select on your TV to view the
HD receiver.
Note: If you have connected a VCR into your entertainment system in a way
that routes the cables from the DST-3000 receiver to your VCR before the
signal reaches the TV, you may experience a distorted picture if you attempt to
record a copy-protected program. These programs are identified by a “Can’t
Tape” symbol in the banner area of the screen. If this occurs, simply stop the
recording process and your picture will automatically correct itself.
Note: When the HD receiver is in HD output mode or in standby (power LED
off), the RF signal received on the IN FROM ANT connector will pass
through to the OUT TO TV connector.