TORXUN AUTOPED M10S.0028, Installation Manual, Page: 62 / 82

Autoped Installation Manual rev 2.0 (100722)
62
Error No Description Cause Elimination Checking Time Reaction
E14 01 Locking/Electr
ic lock The Door/Gate got caught in
the locking/electric lock Check the function of the
locking/electric lock When opening from
a closed position H
02 The inverted operation has
no locking, or the
interlocking force Fch has
not been programmed Program/increase the interlocking
force Fch At the end of the
teach procedure W
E15 01 Obstacle
during
opening Too many successive
obstacles have occurred
•
Examine the installation
•
Remove the obstacle
•
Move the Door/Gate to the
target position
Permanent H, A
Restart after
60 seconds
02 Obstacle
during closing
E16 01 Temperature Temperature on output level
has reached 178°F Allow the unit to cool down Permanent A
Drive unit
functions
with
reduced
power
02 Temperature on output level
has reached 196°F A
Drive unit
has stopped
E20 01 SER test
(Swing side
safety) SER test signal unsuccessful SER short circuit to the earth.
Check the cabling of the sensor or
the jumper
Prior to closing A
02 SER too slow SER reacts too slowly. Check the
cabling for the sensor. Check for
polarity reversal/test signal. E20-01 and E20-02
together, no line in
between, like E21
E21 01 SES test
(Push side
safety) SES test signal unsuccessful SES short circuit to the earth.
Check the cabling of the sensor or
the jumper.
Prior to opening A
02 SES too slow SES reacts too slowly. Check the
cabling of the sensor. Check for
polarity reversal/test signal.