TORXUN AUTOPED M10S.0028, Installation Manual, Page: 47 / 82

Autoped Installation Manual rev 2.0 (100722)
47
maximum is 9.
⚠
TORXUN recommends setting Vo between 1-3 for initial set up. Once the
operation of the gate is confirmed, then the desired speed can be finalized in
compliance with ANSI 156.19.
⚠
STEP 10: Vc
o
Vc controls the Velocity/speed at which the gate closes.
o
Default is set to 9, use the joystick left and right to select the desired speed. Press
the joystick in to confirm the selection; i.e. In LowEn ON mode, the selection
maximum is 9
⚠
TORXUN recommends setting Vc between 1-3 for the initial set up. Once the
operation of the gate is confirmed, then the desired speed can be finalized in compliance with
ANSI 156.19
⚠
STEP 11: Invers
o
Using the joystick left
and right, set Invers to “OFF”. Press the joystick in to confirm
the selection.
o
Invers refers to configuring the Door/Gate to open when power is lost. In such rare
applications the gate will default (spring) to open and operate to close.
STEP 12: Teach
o
Press the joystick in to move to the next selection.
o
“Teach ok?” will appear on the screen
o
Press the joystick in again and you will hear beeping as well as see a ten (10) second countdown on the screen.
o
Once the countdown ends, the gate will open, pause, and then close while beeping. If no errors occur, the LCD display will
display “Done!” with “E11” underneath it.
o
E11 requires the operator to be run through one more full Open and Close cycle via activation command to confirm the
settings.
⚠
ATTENTION: At this point, clear the area of any persons or objects in the path of the gate to avoid injuries or
damages. Proceed to the next step once the path of the gate is clear.
⚠