TORXUN AUTOPED M10S.0028, Installation Manual, Page: 27 / 82

Autoped Installation Manual rev 2.0 (100722)
27
V.1 INSTALLATION: 3-FUNCTION ROCKER SWITCH
(see next section for the optional Key Switch)
Provided with your operator is a 3-function switch that switches the operator and door/gate function to one of three modes:
a. Manual mode
– door/gate has no automation; gate can be manually operated by pushing or pulling
b. Normal mode
– door/gate opens and closes automatically based on activation inputs and programming
c. Hold mode
– door/gate opens and stays open allowing for continuous access
NOTE: The Switch can be installed at the bottom left or right of
the AutoPed operator; knockouts are provided at both
ends
STEP 1 Choose and punch out one knockout at the bottom of
the AutoPed chassis (NOTE: The following
illustrations show the use of the left knockout)
STEP 2 Feed the switch wires through the knockout
STEP 3 Sit the switch body squarely on the chassis
STEP 4 Feed the switch wires through the rubber grommet;
connect to Block X110 as shown in drawing below;
(see schematic circuit in Fig 1.7b in the following page)