TORXUN AUTOPED M10S.0028, Installation Manual, Page: 17 / 82

Autoped Installation Manual rev 2.0 (100722)
17
II.2 INSTALLATION: RIGHT-HAND MOUNTED AUTOPED ON HEADERS LESS THAN 4
”
STEP 1 Put up the StiffenerPlate on the header
STEP 2 Align the StiffenerPlate to the corner of the right
hinge jamb and bottom of header; marked
“X”
on
the drawing
STEP 3 Center-punch pilot holes 1,2,3
STEP 4 Drill
1/16” pilot holes 1,2,3
STEP 5 Fasten
8
StiffenerPlate through holes 1,2,3
STEP 6 Mount
9
operator Chassis to StiffenerPlate
STEP 7 Mount
10
Motor-Drive assembly to operator Chassis
STEP 8 Proceed to Section
III or IV to continue installation of the
swing arm assembly
8
Type, size, and material of fasteners by installer
9
Use screws NF 7/16 x 20 x 3/4 included in kit to mount
10
Use screws M6 x 1.0 x 12 included in kit to mount