TORXUN AUTOPED M10S.0028, Installation Manual, Page: 39 / 82

Autoped Installation Manual rev 2.0 (100722)
39
IX.2 SETUP SEQUENCE FOR INTERLOCK/SALLY PORT/AIRLOCK
IMPORTANT NOTE: The AutoPed must be initially programed for basic functions before it can be setup for Interlock/Sally
Port Operation. Refer to Section XI: Quick Start Programming for this purpose.
The gates can be spaced apart from each other and connected to each other via a CAN BUS connection to create an interlocking
system similar to an air lock or sallyport, Fig IX.2. When Gate A gets an open command, it will block out any inputs to Gate B until
Gate A is fully closed. The same is true for Gate B. When Gate B is opened, Gate A will not be able to open until Gate B is fully
closed.
STEP 1 CAN BUS wire between gate A and gate B Operators
•
Wire the AutoPed in gate A to the AutoPed in gate B. Run the CAN BUS wire between terminal X117 on each
control board; (see item X117 in Section XIV Terminal Connections and Wiring Schematics on p.67 )
STEP 2 InterL
•
Enter the DoubleD menu
•
Make sure that DoubleD is off in the
Double Door menu.
•
Using the joystick toggle down to InterL
o
Set one control unit to side A and
the other to side B
•
With the two control units set to
interlock A and B respectively, they will
work independent of each other but
not allow input commands to be
activated on one gate until the other
has completed its cycle
Fig IX.2 Interlock/Sally Port