TORXUN AUTOPED M10S.0028, Installation Manual, Page: 48 / 82

Autoped Installation Manual rev 2.0 (100722)
48
XI.3 ADDITIONAL PROGRAMMING OPTIONS
Before completing the installation, install any additional hardware or make further programming adjustments. These may include:
a. Push and Go (when the gate is pushed open a programmable set of degrees, the AutoPed will take over and open the
gate the rest of the way; Section VII.7 APuGO in the Configuration Menu).
b. Internal Physical Stop Kit P/N: M10S.0040 (a mechanical option which prevents the gate from being forced beyond 105
degrees to protect the AutoPed operator; see Section VII Installing the Optional Positive Stop
c. Closing Spring Preload (adjust the pressure of the door/gate closure to overcome the gate slamming or not fully latching);
see Section VIII Adjusting The Closing Spring Load.
d. Programming for Double Door system; refer to Section IX.
e. Programming for the Interlock Sally Port; refer to Section IX.
XI.4 FINAL ADJUSTMENTS AND COMPLIANCE TO ANSI 156.19
Make final adjustments to the controller programming and gate operation.
ANSI 156.19 is a safety standard that protects pedestrians when using a low energy automatic door/gate. The AutoPed is designed
so that each installation can comply with this standard.
⚠
IMPORTANT
It is the responsibility of the INSTALLER to adjust the AutoPed so that the gate operates in compliance with ANSI 156.19.
Each gate is different so adjustments must be made on a gate-by-gate basis. Refer to the ANSI 156.19 standards for the
tables that prescribe:
•
The speed/velocity of the opening and closing of gate being installed based on its width and weight. Speed is adjusted in
the Vo and Vc settings in the Parameters menu.
•
The force of the gate when opening and closing. Force is adjusted in the Fo and Fc settings in the Parameters menu.
•
Use a Door Pressure Gauge tool to properly calibrate the force (pressure) of the opening and closing of the gate panel; Fig XI.4
•
Signage
– Attach signage(s) to Door/Gate and activation switches as specified by ANSI 156.19
Fig XI.4 Typical Door Pressure Gauge
Tool (refer to Vendor’s Instructions on use)