TORXUN AUTOPED M10S.0028, Installation Manual, Page: 24 / 82

Autoped Installation Manual rev 2.0 (100722)
24
IV.2 INSTALLATION: TRACK ARM ASSEMBLY
NOTE:
•
Use the Track Arm with a standard 20mm Spindle
Extension.
•
If the 20mm Spindle Extension is not sufficient to extend
the Track Arm down to the Door/Gate frame, use the
optional 30mm or 50mm extensions
•
Make sure that the swing of the Track Arm clears the top
of the gate frame by at least 1/2
” and that the Door/Gate
swing is unobstructed by the Track Arm assembly
STEP 1
Assemble the Track Arm to the AutoPed
STEP 2
Place the AutoPed up onto the Header
STEP 3
Align the AutoPed Chassis to the Hinge Centerline
STEP 4 Move the AutoPed up or down (
↕
) until bottom of Track
Arm clears the top of the Door/Gate frame by a minimum
gap of
½” throughout the top of the Gate Frame
Fig IV.3 Track Arm Assembly