TORXUN AUTOPED M10S.0028, Installation Manual, Page: 53 / 82

Autoped Installation Manual rev 2.0 (100722)
53
TLock Low energy 0.5s 0.0-4.0s Sets amount of time Door/Gate panel will press against lock to engage
it.
Flock Low energy 2.0A Off-7.0A Sets amount of force applied to the Door/Gate panel to engage the
lock at the closed position. It is only active if TLock setting is greater
than 0.
FSlam Low energy Off Off-10 Accelerating function (Force Slam). For example: when a Door/Gate
panel needs to be forced shut due to a latch or heavy seals.
FWind Low energy Off Off
❖
Wind load detection optimized for exterior doors/gate panels
❖
Assuming that a gust of wind is not a hard obstacle which will stop
the door, the
motor current will rise “slowly.” In this case the
AutoPed control unit will supply additional power to continue the
door movement.
❖
When FWind is turned ON, TORXUN strongly recommends the
use of Door/Gate panel mounted sensors to stop or reopen the
door if an obstacle is detected during the door cycle
Open
Close
Both
Fo Low energy 9 0-9
❖
Opening force (force open) when an obstacle is detected during
open/close cycle or both
❖
In standard mode obstacle detection cannot be switched on/off. It
can be adjusted with parameters for
“Fo”=force opening and
“Fc”=force close. To make obstacle detection least sensitive, set
both parameters on 9. To make obstacle detection most sensitive,
set both parameters on 0. (Caution, this can allow the drive to
react to slight changes in wind)
Fc Low energy 9 0-9
Foh Low energy 4 0-9 Hold open force (force hold open)
Fch Low energy 0.0A 0.0A-3.5A
❖
Interlocking force (force close hold) automatically programs Flock
and FDelay if these settings are set at 0.
❖
If there is no electric lock and the interlocking force Fch is not
adjusted, error 14/02 will be displayed as a warning after the teach
1 procedure and the Door/Gate will endlessly reopen.
LowEn Low energy On On Door/Gate panel is low energy in both directions. Door/Gate panel is
activated by a knowing act.
Width Low energy 48in 30-63in
Width of the Door/Gate panel from edge to edge.
⚠
UL approval for
maximum width of 63
”
⚠
Weight Low energy 100~250lbs 100-550lbs
Weight of the Door/Gate panel. ⚠ UL approval for 250lbs ⚠
Ao Low energy 95° 20°-190° Opening angle of the door (angle open)
Teach must be activated after this setting has been changed