Adjusting the Steering Linkage (continued)
3.
For GreensPro 1260:
Note:
Each steering linkage rod includes 2 ball joints and 2 hex nuts. To
allow adjustment, 1 ball joint and 1 hex nut has left-hand threads, and
1 ball joint and 1 hex nut has right-hand threads. Before attempting to
loosen the hex nuts for linkage adjustment, inspect the threads on the
linkage rod to determine the thread direction.
A. Loosen the hex nuts and turn the short (front) steering rod (item 3 in
) until the front outer steering roller is aligned with the chassis
frame. Do not tighten the steering pivot rod hex nuts at this time.
g274017
Figure 56
GreensPro 1260
1.
Block
3.
Steering rod – short
2.
Steering pivot assembly
4.
Steering rod – long
B. Loosen the hex nuts of the long (rear) steering rod (item 4 in
until the rear outer steering roller is aligned with the chassis frame. Do
not tighten the steering pivot rod hex nuts at this time.
C. Place a straightedge across the steering rollers to ensure the steering
rollers are in alignment with each other (
). Adjust the steering
rods as necessary to achieve alignment.
g240026
Figure 57
1.
Straightedge
2.
Steering roller
GreensPro
™
1240/1260
Page 7–7
Chassis: Adjustments
14211SL Rev A
Summary of Contents for GreensPro 1240
Page 4: ...Reader Comments Page 4 GreensPro 1240 1260 14211SL Rev A...
Page 8: ...Preface Page 8 GreensPro 1240 1260 14211SL Rev A...
Page 14: ...Safety Safety and Instructional Decals Page 1 6 GreensPro 1240 1260 14211SL Rev A...
Page 30: ...Specifications and Maintenance Special Tools Page 2 16 GreensPro 1240 1260 14211SL Rev A...
