Toro GreensPro 1240, Service Manual

Page: 82 / 186

After Repairing or Replacing the Components (continued)
4. Lubricate the O-rings, ED seals, and dowty seals with clean hydraulic fluid
before installing the hydraulic components.
5. Remove all the caps or plugs from the hydraulic hoses, hydraulic fittings, and
components before connecting them.
6. Use proper tightening procedures when installing the hydraulic hoses and
fittings; refer to Installing the Hydraulic Hoses and Tubes (page 5–12) and
Installing the Hydraulic Fittings (page 5–14) .
7. After you complete the repairs, check the control linkages or cables for
proper adjustment, binding, or broken parts.
8. After you complete the repairs, clean any hydraulic fluid from components,
hose connections, and fittings to prevent future accumulation of dirt and
unwanted material.
9. After you disconnect or replace any hydraulic components, operate the
machine functions slowly until the air is out of the system; refer to Charging
the Hydraulic System (page 5–42) .
10. Check for hydraulic fluid leaks; refer to Checking the Hydraulic Lines and
Hoses (page 5–37) . Shut off the engine and repair leaks if necessary.
11. Check the hydraulic fluid level in the hydraulic tank and add correct quantity
of fluid if necessary.
Hydraulic System: Service and Repairs Page 5–36 GreensPro ™ 1240/1260
14211SL Rev A