Servicing the Steering Rollers
g239521
Figure 83
1.
Roller tube (short)
5.
Roller sleeve
9.
Bearing spacer (2 each)
2.
Roller shaft (short)
6.
O-ring (2 each)
10.
Locknut (2 each)
3.
Roller tube (long)
7.
Bearing (4 each)
4.
Roller shaft (long)
8.
Flocked seal (4 each)
1. Remove the parts as necessary to repair the steering rollers. Discard the
flocked seals and O-rings.
2. Clean all the components before assembly.
3. If a bearing or bearing housing is removed, ensure that it is pressed into
position fully during installation.
4. Thread the roller shafts into the roller sleeve and tighten the roller shafts
to
92 to 124 N∙m (68 to 91 ft-lb)
.
5. Install new flocked seals and O-rings. Install the flocked seals with flocked
side of seal against the bearing.
6. Thread the locknuts onto the roller shafts and tighten the locknuts to
92 to
124 N∙m (68 to 91 ft-lb)
.
Chassis: Service and Repairs
Page 7–42
GreensPro
™
1240/1260
14211SL Rev A
Summary of Contents for GreensPro 1240
Page 4: ...Reader Comments Page 4 GreensPro 1240 1260 14211SL Rev A...
Page 8: ...Preface Page 8 GreensPro 1240 1260 14211SL Rev A...
Page 14: ...Safety Safety and Instructional Decals Page 1 6 GreensPro 1240 1260 14211SL Rev A...
Page 30: ...Specifications and Maintenance Special Tools Page 2 16 GreensPro 1240 1260 14211SL Rev A...
