Toro GreensPro 1240, Service Manual

Page: 77 / 186

Adjusting Procedure for GreensPro 1240 (continued)
g271843
Figure 26
GreensPro 1240
1. RTN adjustment screw
3. To stop drive roller rotation to the left
2. Control arm assembly 4. To stop drive roller rotation to the right
B. Rotate the control arm assembly in the opposite direction of the drive
roller rotation in small increments.
C. Tighten the RTN adjustment screw to 24 to 30 N·m (18 to 22 ft-lb) .
D. Start the engine, set the throttle to full engine speed and check for drive
roller rotation. repeat adjustment if necessary.
E. When the drive roller does not rotate, shut off the engine and attach the
linkage rod to the transmission control arm.
9. Start the engine and set the throttle to full engine speed.
10. Place a straightedge across the front of both motion control pedals to align
the pedals with each other ( Figure 27 ).
GreensPro ™ 1240/1260 Page 5–31 Hydraulic System: Adjustments
14211SL Rev A