Toro GreensPro 1240, Service Manual

Page: 78 / 186

Adjusting Procedure for GreensPro 1240 (continued)
g241036
Figure 27
GreensPro 1240
1. Motion control pedal (2 each) 2. Straightedge
11. If the drive roller rotates, adjust the linkage rods so the drive roller does not
move when the motion control pedals are aligned with each other.
Note: Each linkage rod includes 2 ball joints and 2 hex nuts. 1 ball joint and
hex nut has left-hand threads, and 1 ball joint and hex nut has right-hand
threads. Before attempting to loosen the hex nuts for linkage adjustment,
inspect the threads on the linkage rod to determine the direction of the
threads.
12. Shut off the engine and install the transmission cover; refer to Installing the
Transmission Cover (page 7–59) .
Adjusting Procedure for GreensPro 1260
1. Park the machine on a clean, level surface and set the transport wheels to
the lowered and locked position. Place a jack stand under the front of the
chassis to prevent the machine from tipping forward. The drive roller must
be off the ground and free to rotate.
2. Remove the transmission cover from the machine; refer to the Removing
the Transmission Cover (page 7–59) .
3. Ensure that the entire motion control linkage assembly is secure and moves
freely in both directions; refer to Motion Control Linkage (GreensPro 1260)
(page 7–17) .
4. Remove the traction cable from the pedal rod pivot ( Figure 28 ).
Hydraulic System: Adjustments Page 5–32 GreensPro ™ 1240/1260
14211SL Rev A