Removing the Drive Roller (GreensPro 1240)
Refer to
for this procedure.
CAUTION
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
1. Remove the transmission cover from the machine; refer to
Transmission Cover (page 7–59)
.
2. Remove the hex nut, spacer, and compression spring (item 3 in
)
from the idler adjustment rod.
g241029
Figure 68
1.
Hex nut
6.
Flat washer (2 each)
2.
Spacer
7.
Locknut
3.
Compression spring
8.
Pivot bushing
4.
Idler adjustment rod
9.
Spacer
5.
Bolt
10.
Idler arm assembly
3. Remove the bolt, flat washers, locknut, pivot bushing, and spacer, and
remove the idler arm assembly from the machine.
4. Remove the drive roller sprocket from the taper lock bushing:
A. Remove the 2 set screws that secure the sprocket to the taper lock
bushing.
B. Oil the thread and the end of 1 of the set screws and insert the screw
in removal hole (
). The bushing removal hole is threaded on
the bushing side.
Chassis: Service and Repairs
Page 7–20
GreensPro
™
1240/1260
14211SL Rev A
Summary of Contents for GreensPro 1240
Page 4: ...Reader Comments Page 4 GreensPro 1240 1260 14211SL Rev A...
Page 8: ...Preface Page 8 GreensPro 1240 1260 14211SL Rev A...
Page 14: ...Safety Safety and Instructional Decals Page 1 6 GreensPro 1240 1260 14211SL Rev A...
Page 30: ...Specifications and Maintenance Special Tools Page 2 16 GreensPro 1240 1260 14211SL Rev A...
