Toro 136-0372, Installation Instructions Manual

Page: 21 / 64

Installing the Agitation Valve Connector
1. Cut off the butt-splice connectors for the pink wire
and black wire of the 3-pin adapter (
Figure 41 ).
Figure 41
1. 3-pin adapter 3. Pink wire
2. Black wire 4. Butt-splice connector
2. Strip 8 mm (5/16 inch) of insulation from the pink and
black wires of the 3-pin adapter (
Figure 42 ).
Note:
You will connect the pink and black wires of
the 3-pin adapter in Installing the Master-Spray Valve
Connector (page 22) .
Figure 42
1. Black wire (3-pin adapter) 3. Removed section of wire
insulation—8 mm (5/16
inch)
2. Pink wire (3-pin adapter)
3. Align the yellow and green wire of the DIN harness
with the white wire of the 3-pin adapter for the
agitation-valve (
Figure 43 ); refer to the wire table for
the agitation valve.
Figure 43
1. 3-pin adapter 3. Yellow and green wire
(DIN harness—agitation
valve)
2. Butt-splice connector
(white wire—agitation
valve)
Wiring Table—Agitation Valve
Wire color codes—DIN wire
harness Wire color codes—3-pin
adapter (agitation-valve
position)
Not applicable Pink
Not applicable Black
Yellow/green White
4. Insert the wire of the DIN wire harness into the
butt-splice connector of the 3-pin adapter.
5. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
6. Use a heat gun to shrink the insulating sleeve of the
butt-splice connector of the wires that you installed
in steps
3 through 5 .
7. Terminate the brown and blue wire of the DIN
connector as follows:
A. Cut the conductors of the brown wire and blue
wire flush with the insulation (
Figure 44 ).
21