Toro 136-0372, Installation Instructions Manual

Page: 27 / 64

Assembling the Valve Actuator to the
Manifold Valve
Perform this procedure if you removed the valve actuator (s)
to install the hose assemblies onto the manifold valve(s).
1. Align valve actuator that you identified in step 1 of
Removing the Valve Actuators (page 25) with the
manifold valve position shown in Figure 51 .
2. Secure the valve actuator to the manifold valve with the
retainer that you removed in step
2 of Removing the
Valve Actuators (page 25) .
11
Connecting the Wiring
Harness to the Valves
No Parts Required
Connecting the Electrical Connectors
for the Section Valve
1. Connect the 3-pin valve harness labeled
LEFT SPRAY
VALVE
into the 3-socket connector for the left spray
valve ( Figure 56 ).
Figure 56
1. 3-socket valve harness
(right spray valve) 4. 3-pin valve harness (right
spray valve)
2. 3-socket valve harness
(center spray valve) 5. 3-pin valve harness
(center spray valve)
3. 3-socket valve harness
(left spray valve) 6. 3-pin valve harness (left
spray valve)
2. Connect the 3-pin valve harness labeled
CENTER SPRAY
VALVE
into the 3-socket connector for the center spray
valve ( Figure 56 ).
3. Connect the 3-pin valve harness labeled
RIGHT SPRAY
VALVE
into the 3-socket connector for the right spray
valve ( Figure 56 ).
27