Operating instructions
As of 06/13
15
C 4.5.1 Connecting infrared emitter
Via infrared communication infrared commands are transmitted from
TLS QuickScout A/D XL
to play-back devices. For this you need an
infrared emitter, which is not included in delivery package of
TLS
QuickScout A/D XL
.
Connect the red/blue marked cable (at TLS types) with screen
in a 2pin Phoenix connector included in delivery.
Then connect the assembled connecting cable of the IR emitter
to the terminal block at the IR port (contact terminals
IR-OUT
and
GND
) at the back side of
TLS QuickScout A/D XL
.
Please ensure that the red respectively blue marked cable (IR
emitter) is connected with the terminal IR and the screen (earth
lead) is connected with the terminal GND .
Then remove the protective film from the IR emitter and
connect the emitter at the relevant end devices directly to the
infrared receiver. This is usually marked with IR.
C 4.5.2 Single and/or dual IR emitter
Up to three IR emitter in series can be connected per output. For this
a single and/or dual IR emitter is available from TLS (
Ident. No.:
864
0027 (single) / 864 0028 (dual)
).
C 4.5.3 Infrared extension
If you need an extension for the infrared cable, a 2-pole cable with
plug and socket is available from TLS.
