Page 24
Installation, use and maintenance guide
Mon Amour
6.3 TRANSMISSION CODES SETTING
If there are several appliances installed in rooms closely to each other or in case of electromagnetic disturbances it may be necessary
to set different transmission codes as this type of interference deactivates operation of the optional Thermocomfort radio control.
To change the transmission codes proceed as follows:
The appliance must be energised and the main switch O/I in the "I" position.
1) Disable the Thermocomfort function. (See Par. 5.6)
2) Switch off the Thermocomfort radio control using the main switch (11).
3) To change the transmission codes, open the battery cover and act as indicated in the figure below.
4)
To change the frequency simply change the order of even only one of the four switches shown in the figure above.
5)
Next switch on the radio control by pressing the main switch (11).
6)
Re-enable the THERMOCOMFORT function.
6.4 CARE AND MAINTENANCE OF THE RADIO CONTROL
The radio control has been designed to the strictest standards and must be handled with great care.
If you observe the guidelines set out below, the radio control will provide a long trouble-free performance:
•
Protect the radio control against precipitation, moisture, liquids and all those substances that could corrode the internal
electronic circuits. If the radio control gets wet, remove it immediately from the battery charger if it is in the process of
charging, remove the battery and leave it open to dry at room temperature for as long as necessary.
•
Do not use or store the radio control in dusty or dirty environments. The dust/dirt could damage the movable parts of the
radio control.
•
Do not store the radio control in very hot environments. High temperatures could shorten the life of the electronic devices,
damage the batteries and deform or even melt plastic parts. Do not store the radio control in too cold environments. When
it heats up (when it returns to normal operating temperature), humidity could form inside it and damage the electronic circuits.
•
Do not drop the radio control, do not hit or bump it and do not shake it. Actions such as these could damage the internal
circuits of the device.
•
Do not use corrosive chemical substances, caustic solutions or detergents to clean the radio control.
All the above guidelines apply to the radio control, the battery, the battery charger, and all the accessories. The parts
subject to wear (such as batteries, keypads, lodging compartments, small compartment parts) are guaranteed for 6
months from the purchase date. The guarantee does not apply if the defect is caused by non-conforming use and/or if
the instructions and guidelines described above are not observed to the letter. Devices or parts returned for replacement
become the property of Thermorossi. S.p.A. The presence of any irregular black-blue lines on the display, also present
when de-energised and/or battery flat or missing, indicate that the glass screen of the display is damaged following a
fall or impact: in this case the breakage is not covered by the guarantee.
CODE SELECTOR FOR HANDHELD RADIO
CONTROL CONTROLLED BY RADIO WAVES
