Page 14
Installation, use and maintenance guide
Mon Amour
5 – DESCRIPTION OF THE CONTROLS
The appliance, when operating, could be hot to the touch, particularly the door of the combustion chamber: take care
when handling the appliance components. Your appliance has obtained the CE marking and has been made to run for
at least one hour to check that it functions correctly. The product must not be used by children, by persons with physical
or mental impairments, by persons who are not familiar with the instructions for use and maintenance of the product (the
instructions are found in this use and maintenance booklet).
CAUTION: Before each use make sure that the brazier is clean and positioned correctly in its lodging.
CAUTION: the door must always remain shut tight when the stove is operating. It is strictly forbidden to open the door
while the appliance is in operation. While the appliance is in operation the smoke exhaust pipes can reach extremely
high temperatures: do not touch them! It is strictly prohibited to use any type of fuel (liquid, solid...) other than pallet to
light up the appliance: lighting must occur automatically as intended and described in this installation, use and
maintenance booklet; consequently, it is also strictly forbidden to feed pellets (or any other material) into the brazier. Do
not place non-heat resistant or inflammable or combustible objects in the vicinity of the appliance: keep them at a suitable
distance. Do not place wet clothing to dry on the appliance. When using a clothes horse, keep at a suitable distance. It
is strictly prohibited to disconnect the appliance from the electrical power mains during normal operation.
5.1 DESCRIPTION OF THE CONTROL PANEL
The control panel is managed by a microprocessor. The control buttons and the various displays are described below.
The control buttons are:
Clock button
Press this button to activate / deactivate the programming. (See para. 5.4),
Ventilation button
Press this button to set the desired level of ventilation: Six ventilation levels can be set on this stove. The fan starts
operating as soon as the temperature inside the stove body rises and the smoke thermocouple gives the signal. The
fan stops automatically when the stove body has cooled sufficiently. The fan cannot be disabled during operation.
Flame button
Pressing this button when the appliance is off activates the START sequence (See Para. 7), sets the combustion
power in the WORK mode (See Para. 7) or shuts off the appliance by activating the OFF sequence (See Para. 7).
Scroll buttons (only in the Menu)
Press MINUS key to lower the value. Press PLUS key to raise the preset value.
Menu button
Press this button to access the main menu. You can scroll the setting screens shown below, which will be described
in detail in the following paragraphs. To access the functions of each subwindow wait a few seconds.
DATE/TIME
This button is used to set the day of the week, the hour and minutes. (See par. 5.3)
CHRONO
This button is used to set the programmed on and off sequences. (See para. 5.4)
