Page 30
Installation, use and maintenance guide
Mon Amour
Legenda:
Key:
FIGURA
FIGURE
9.3 REPLACING THE BATTERY OF THE REMOTE CONTROL
When the infrared remote control does not send out the transmission signal (the led comes not on), the battery must be replaced.
Using a suitably sized Philips screwdriver, undo the screw of the battery cover on the back of the remote control and replace the
battery. The dead battery must be disposed of in compliance with the regulations in force.
9.4 REPLACING THE BATTERY OF THE CONTROL PANEL
Inside the control panel there is a
buffer battery type CR1632. When
the time and programming are not
being memorised, then the battery
needs replacing. Undo the two
screws 1 that can be reached from
the rear of the appliance, remove the
control panel and remove the
protective cover.
To remove the cover simply press
your fingers towards the centre in
order to press the two tabs A and B
as illustrated in the following two
figures.
Pull the cover outwards and replace the battery. The dead battery must be disposed of in compliance with the regulations in force.
