I
Page 15
installation, use and maintenance guide
Mon Amour
LEVEL
Is used to change the rotation speed of the smoke suction unit. (See para. 5.5)
THERMOCOMFORT
This button is used to activate the connection with the optional handheld radio control. (See para. 5.6)
Display
The following information can appear on the display:
Displays the preset combustion power, and consequently the pellet consumption, by the number of bars that are
lit up around the flame symbol, using this logic:
One bar lit up: Minimum combustion power (and therefore with minimum pellet consumption)
Two bars lit:
Second combustion power
Three bars lit:
Third combustion power
Four bars lit:
Fourth combustion power
Five bars lit up:
Maximum combustion power (and therefore with maximum pellet consumption)
No bars lit up:
The appliance is OFF
Displays the preset ventilation power, and consequently the room fan speed, by the number of bars that are lit
up around the fan symbol, using this logic:
One bar lit: Minimum ventilation power
Two bars lit:
Second ventilation power
Three bars lit:
Third ventilation power
Four bars lit:
Fourth ventilation power
Five bars lit:
Fifth ventilation power
Six bars lit:
Maximum ventilation power
Dashes appear along the top of the display, and each dash corresponds to one day of the week set by the user
(e.g. 1 corresponds to Monday, 2 corresponds to Tuesday… etc.).
The operating status of the appliance appears below these dashes, that is START, OFF or WORK. And the current
time set by the user appears below this word.
The presence in the display of the clock symbol indicates that the CHRONO programming has been enabled; if this
symbol does not appear it means that the CHRONO programming has been disabled. (See Par. 5.4)
5.2 DESCRIPTION OF THE POWER PANEL
The components of the power panel are described below:
1) Electrical power outlet 220V-240V 50Hz
2) Main switch 0/I.
3) Test light for pellet feed motor.
The light comes on simultaneously with the activation of the pellet feed
motor.
4) Cap for reset thermostat button.
If the reset thermostat overheats stop the pellet feeder. The appliance
must cool down before you can restart the appliance. After verifying
and eliminating the causes of the event, undo the protective cap and
press the button.
5) Safety fuse.
Legenda:
Key:
Riarmo
Reset
Spia motoriduttore
Ratio motor led
3
4
2
1
5
