Page 18
Installation, use and maintenance guide
Mon Amour
In the event of a programmed cycle on always ensure that the brazier is clean and in the correct position. Failure to
clean the brazier can reduce and/or affect the life of the spark plug as it would be subjected to high temperatures due
to poor cooling. It is recommended to set ON/OFF cycles times lasting no less than 2 hours, in order to save energy
and for the proper operation of the appliance.
.
Enabling the programmed cycles:
Back in the initial screen, to enable the appliance to carry out the ON/OFF cycles as programmed it is necessary to press the
Clock
Button
.
The image of a clock will appear on the main screen:
The programmed cycles are now enabled.
When the programmed cycles are enabled (a clock symbol appears on the display) it will not be possible to use
an additional chronothermostat
(see Para. 8.2)
.
Disabling the programmed cycles:
To disable the appliance from carrying out the programmed ON/OFF cycles press the
Clock Button
once again.
On the display the clock symbol will disappear. This operation disables the weekly program that has been set by the user but does
not delete or reset the times.
Resetting the programmed cycles:
Moreover, it is possible to reset, in other words delete, all the programmed cycles entered by the user by holding down the
Clock
Button
in the initial screen for approx. five seconds.
The words
CLEAR TIMERS
will appear
momentarily on the screen.
Do not release the button until the text CLEARED appears on the screen. Only the appearance of the words CLEARED
signal that the previously entered programmed cycles have been deleted. When the programmed cycles are active the
operating level at start up, that is the combustion power, will be the same level set before the last time the machine was
shut off: that is, only if it was a programmed shut off, not if the machine was shut off by means of a manual action. Manual
shut down can only be carried out with the programming disabled. If after a manual shut off the programmed cycle re-
enables, at the next programmed start up the appliance will be on the first combustion power level.
5.5 LEVEL: OPERATING LEVEL SETTING
The appliance must be energised and the I/0 switch in position “I".
Your appliance is delivered with an excellent program installed that favours combustion efficiency; the program is called LEVEL 1.
However, if you are using pellets with a higher than normal incidence of residues after combustion in the brazier, it is possible to
select alternative levels:
LEVEL 2
is an operating program that accelerates the speed of the smoke suction unit in proportion to all the combustion
power levels. This level must be set when the user notices a weak, high and very dark flame. Attention: this
modification does not authorise the use of below-standard pellets, or no vacuum in the flue outlet.
If using loosely compressed pellets, you could select:
LEVEL 0:
is an operating program that decelerates the speed of the smoke suction unit when using loosely compressed
pellets and/or when the flue outlet has a very high vacuum, over 2 mm water column (20 Pascal).
The pellet consumption value remains unchanged regardless of the selected operating level. These variations will only change the
rotation of the smoke suction unit in the WORK stage, all the other stages will not undergo any changes.
Select the required Level by acting as follows:
1) Press the Menu Button three times quickly and the following box will appear:
After a few seconds the following screen will appear on the display: