![background image](http://html1.mh-extra.com/html/thermofisher-scientific/912a0604/912a0604_manual_1105622011.webp)
Installing the iN10/iN10MX
This document contains confidential or proprietary information of Thermo Fisher Scientific. Neither this
document nor the information therein is to be reproduced, distributed, used or disclosed, either in whole or
in part, except as specifically authorized by Thermo Fisher Scientific.
8/3/2020
Page 11 of 61
24.
Attach the iZ10.
If an iZ10 was not ordered, continue with step 25.
24.1.
Remove the iN10 base cover.
Using a short handled Phillips
screwdriver, remove the four screws from the base cover of the
iN10 and set the screws aside.
Carefully lift the cover up being careful not to disturb the contact
alert cable on the Z stage ring and remove the lower cover from the
microscope. Set the cover aside.
24.2.
Remove the 3 purge plugs from the base plate of the iN10.
Using needle nose pliers; grasp and pull up on the purge plugs and
remove them from the baseplate.