Thermo Scientific Surveyor PDA Plus, Hardware Manual

Page: 28 / 136

2
Installation
Installation Checklist
8 Surveyor PDA Plus Detector Hardware Manual Thermo Scientific
Installation Checklist
The following installation checklist is a brief summary of the steps that you need to complete
in sequence for the proper installation of the PDA detector.

Unpack and inspect your instrument (see page 9 ).

Read the safety notices in the preface.

Make the initial instrument preparations (see page 9 ).

Check the power settings and fuses (see page 10 ).

Make the initial back panel connections (see page 11 ).

Connect and install the LightPipe flow cell (see page 15 ).

Power on the detector for the first time (see page 19 ).

Install software and connect remote communication outputs, as required (see page 19 ).

Download the PDA detector firmware, if required. See Appendix A, “Firmware.”

Configure the Surveyor PDA Plus Detector for control from your chromatography data
system. See
Chapter 3, “Configuration.”

Calibrate the Surveyor PDA Plus Detector (see “Calibrating the PDA Detector” on
page 31 ).
This detector was installed by:
(Name) (Date)