Thermo Scientific Oretronic III, Operating & Service Manual

Page: 32 / 152

Installing the TMD
2-4 Installing the TMD Thermo Fisher Scientific
REC-4105 Rev L
The TMD coil support structure and coil(s) are normally packaged on a
wooden skid and may be lifted with a forklift or crane. Do not lift the
equipment using the support structure; use the exterior wooden structure.
Use care when lifting this equipment to avoid damage to the coil(s).
The TMD control unit is normally packaged sealed in foam, which is
then placed in a cardboard carton. This carton should be handled
manually. Lift the carton observing the “This Side Up” labels. Do not
use hooks. Use extreme caution when handling this equipment because
the electronics are extremely delicate.
The Tramp Metal Detector has been properly packaged for shipment.
Inspect all packages before opening. If there is any evidence of shipping
damage, notify the shipping carrier immediately; the carrier may be
responsible for the damage.
After unpacking, inspect the unit for broken or damaged components.
The Tramp Metal Detector and associated equipment can be safely
stored, with the cover secured and hole plugs installed, in ambient
temperatures between –67 and 158 × F (–55 to 70 × C). The control unit
should be protected against moisture.
This section provides procedures for installing the coil support structure
and coils and for mounting and wiring the control unit. The installation
procedures are different for dual coil and under belt single coil TMDs.
The coil support structure is shipped from the factory partially
assembled. Coils are mounted on the cross members. Refer to Outline,
Mounting and Assembly, Coil Stand (D07328C-A003) for assembly
information. Refer to Installation Placement (D07328C-A002) for
detailed information about positioning the system components.
Note
: The coil support structure must be located so that the conveyor
will stop before any tramp is discharged. Use the following procedure
to assemble and install the coil support structure and coils on your
conveyor.
Equipment
Handling
Inspection and
Unpacking
Inspection
and
Unpacking
Installing the
TMD
Installing the Coil
Support
Structure and
Coils for a Dual
Coil TMD