Thermo Scientific Oretronic III, Operating & Service Manual

Page: 63 / 152

Operating the TMD
Thermo Fisher Scientific Operating the TMD 3-17
REC-4105 Rev L
When the TMD is in Setup/Calibrate mode, the display shows each
individual variable that needs to be set up. The counter shows the
current (default) value of the variable.
The up and down SCROLL arrow keys move the scroll of display
“screens” up and down one screen at a time. To access a variable, press
a SCROLL key to move the display to that variable. The
Setup/Calibration Displays are referenced in Section “Initial Setup
Procedure”.
Note
: When either end of the display scroll is reached, scrolling ends.
The scroll does not wrap.
The up and down VALUE arrow keys change the value of the variable
shown in the counter. Pressing the up arrow increases the value.
Pressing the down arrow decreases the value. Values increase or
decrease only within the range for the individual variable.
To change a variable, press a VALUE arrow key until the value you
want is displayed in the counter. You must press the ENTER key to use
the new value. When the value of a variable has been changed but not
entered, the value of the variable flashes as a reminder to press ENTER.
If the variable has more than one digit, each one flashes individually.
Note: After you press ENTER to change a variable, the display will
show the message XXXX DNE, where XXXX indicates the variable.
Follow this procedure for the initial setup of the Tramp Metal Detector.
Refer the Setup/Calibration Displays references in the left margin for the
order of the displays used during setup.
Note
: When setting up or changing variables, the new values are not
stored in system memory until you return to Run mode. If you power
off the TMD while you are sill in Setup/Calibrate mode, all changes are
lost.
Using the Display
Scroll
Entering Values
Initial Setup
Procedure