Electrical safety
WARNING!
Fuse Installation.
Before installing the instrument, verify that the fuses are properly
installed and the fuse voltage matches the supply voltage. Replace fuses only with the type and
rating specified for the unit. Improper fuses can damage the instrument wiring system and cause a
fire.
WARNING!
Voltage Selector Switch.
Before installing the instrument, verify that the voltage
selector switch is set for the supply voltage. This will prevent damage to the instrument, reduce
risk of fire, and enable proper operation.
WARNING!
Ensure appropriate electrical supply.
For safe operation of the instrument:
·
Plug the system into a properly grounded receptacle with adequate current capacity.
·
Ensure the electrical supply is of suitable voltage.
·
Never operate the instrument with the ground disconnected. Grounding continuity is required for
safe operation of the instrument.
WARNING!
Power Supply Line Cords.
Use properly configured and approved line cords for the
power supply in your facility. If the line cord is damaged, contact Technical Support.
WARNING!
Disconnecting Power.
To fully disconnect power either detach or unplug the power
cord, positioning the instrument such that the power cord is accessible.
Cleaning and decontamination
CAUTION!
Cleaning and Decontamination.
Use only the cleaning and decontamination methods
that are specified in the manufacturer user documentation. It is the responsibility of the operator (or
other responsible person) to ensure that the following requirements are met:
·
No decontamination or cleaning agents are used that can react with parts of the equipment or with
material that is contained in the equipment. Use of such agents could cause a HAZARD condition.
·
The instrument is properly decontaminated a) if hazardous material is spilled onto or into the
equipment, and/or b) before the instrument is serviced at your facility or is sent for repair,
maintenance, trade-in, disposal, or termination of a loan. Request decontamination forms from
customer service.
·
Before using any cleaning or decontamination methods (except methods that are recommended by
the manufacturer), confirm with the manufacturer that the proposed method will not damage the
equipment.
Appendix E
Safety
Instrument safety
E
CTS
™
DynaCellect
™
Magnetic Separation System User Guide
187
Summary of Contents for A55867
Page 197: ......
