![background image](http://html.mh-extra.com/html/thermo-king/super-ii-sr/super-ii-sr_manual_1104381102.webp)
Refrigeration Service Operations (Rev 6/98)
92
Disassembly
1.
Remove the piston end cap (round end).
2.
Remove the cotter pin from the castle nut and remove
the nut.
3.
Remove the spring and piston.
4.
Loosen all the bolts on the bellows end cap.
CAUTION: This end cap is under slight spring
pressure.
5.
Break the gasket free and remove the end cap.
6.
Note the number of shims next to the cap. These can be
reused.
7.
Remove the bellows.
8.
Inspect all the parts.
•
Piston and cap for wear (scuff marks).
•
Body for stripped threads.
1.
Inspect Cap
2.
Inspect Spring
3.
Shims
•
Bellows end cap for damage in the pilot hole.
NOTE: The bellows is normally replaced.
9.
Clean the parts that will be reused.
Reassembly
1.
Install the bellows with the O-ring in the housing.
2.
Center the spring on the bellows shoulder.
1.
Inspect for Wear
1.
Inspect for Damage
Summary of Contents for Super II SR+
