Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
58300000156573_ARA_EN_B
Page 53 of 119
1. Follow all safety precautions and steps in
.
2. Follow all steps in
Accessing Components under the Maintop
.
3. Remove knob from valve stem by slowly pulling knob straight out,
away from control panel.
4. If obstructing access to the Five-Position Oven Function Selector,
remove the burner support rail (with jet holder assemblies
attached) by following the steps in
, page
5. At the back of the control panel, disconnect the plastic multi-pin
connector from the pins on the five-position oven function selector
(see Figure 99).
6. At the front of the control panel, remove and retain the two T-20
screws on the bezel which are attached to the Five-Position Oven
Function Selector (see Figure 100), and then remove the bezel.
Figure 100: Screws on Bezel of Oven Function Selector
7. At the back of the control panel, remove the five-position oven
function selector and replace it if necessary.
4.5.12 Three-Position Oven Function Selector – Removal and
Replacement
The Three-Position Oven Function Selector is for the small oven on
48-inch ranges, as well as on 30-inch and 36-inch ranges.
NOTE:
Depending on the range model and FD number, the Three-
Position Oven Function Selector switch may or may not be fastened
with a clip-shaped bracket (see Figure 102).
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 101: Three-Position Oven Function Selector (Typical Models
Shown)
Figure 102: Front and Back of Three-Position Oven Function Selector
(Typical Model Shown with Retaining Bracket)
1 Retaining
bracket
