Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
58300000156573_ARA_EN_B
Page 94 of 119
Figure 183: HSI for Broil Burner
1
Location of screws (2) and nuts with lock washers
(2) that secure the HSI onto HSI retaining bracket
2
Spade wire connectors (2) on HSI
1. Follow all safety precautions and steps in
.
2. Remove all trays from the oven.
3. Remove oven doors (see
Oven Door Removal, Installation
,
4. Remove the backguard (see
Backguard and Island Trim Removal
, page
).
5. Remove the two back panels (see
page
).
6. From the back of the range, disconnect the hot surface igniter
(HSI) wire (spade) connectors (see Figure 183 and Figure 184)
and make a note of which wires are connected to each of the two
different terminals.
NOTE:
It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when re-assembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
Figure 184: HSI Wires at Broil Burner
1
HSI wire with spade connector (2)
4.7.5.1
Hot Surface Igniter for Broil Burner – Removal and
Replacement
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all steps in
Broil Burner Components – Removal and
page
2. From inside of the range, remove and retain the two screws and
respective nuts with lock washers that hold the HSI onto the HSI
retaining bracket (see Figure 183 and Figure 185).
