Themis USPIIi-1v, Hardware Manual

Page: 92 / 128

USPIIi-1v Hardware Manual
A-24
Themis Computer
A.4.3 PMC Carrier Slot User I/O
This section provides the pinout of the 64 PMC User I/O signals that can be brought from PMC cards to the
VME P2 connector of the PMC Carrier board. Also see Appendix A.4.2, "PMC Carrier Board VME P2
Connector," for additional information. Two configurations are possible:
– 64 user signals from PMC slot #1 (connector J5), and none from slot #2. This is the default
configuration.
– 32 user signals from PMC slot #1 (connector J5) and 32 from slot #2 (connector J8). For this
configuration, a special adapter must be installed on connectors J11 and J12. Consult the factory
Both PMC Carrier Slot #1 and Slot #2 use the connector type illustrated in Figure A-15, "PMC Carrier Board
User I/O Connector."
• Connector Type: 64 Pin, Female, 10mm, Dual Row
• Connector Manufacturer: AMP
• Manufacturer’s Part Number: 120528-1
Figure A-15. PMC Carrier Board User I/O Connector
A.4.3.1 PMC Carrier Slot #1: 64 Bit User I/O Configuration
Table A-17. PMC Carrier Slot #1 with 64 Bits of User I/O
Pin Number Signal Pin Number Signal
1 PMC IO C1 33 PMC IO C17
2 PMC IO A1 34 PMC IO A17
3 PMC IO C2 35 PMC IO C18
4 PMC IO A2 36 PMC IO A18
5 PMC IO C3 37 PMC IO C19
6 PMC IO A3 38 PMC IO A19
7 PMC IO C4 39 PMC IO C20
8 PMC IO A4 40 PMC IO A20
9 PMC IO C5 41 PMC IO C21
10 PMC IO A5 42 PMC IO A21
11 PMC IO C6 43 PMC IO C22
12 PMC IO A6 44 PMC IO A22
13 PMC IO C7 45 PMC IO C23
1
2