Teyme ASM1-200-24, Instructions Manual

Page: 16 / 46

Mistblowers Notice of Instructions
Page 15 of 43
4.2.8. Distributor
The sprayer can be provided with different sorts of distributors to control the spraying.
4.2.8.1. GRH Hand-operated Distributor
Distributor with a single-control lever for the spraying selection. A knob is included to raise or lower pressure and a
manometer.
DANGER!
It is forbidden to use this sort of control in tractors with closed cab.
4.2.8.2. System 1 Electrical Distributor
Electrical distributor with control box which allows to open and close right and left sides independently. It includes pilot
light warning about the opening of sector. This distributor includes pressure compensation valves and pressure hand-
operated regulation.
4.2.8.3. System 2 Electrical Distributor
It has the same fonctions as system 1. Additionally, it allows pressure regulation by an electrical valve and it includes an
added selector on the control board.
4.2.8.4. System 3 Electrical Distributor
With the same fonctions as system 2 with an added electrovalve which allows the opening and closing of the general
circuit by means of an added selector to the control board. Warning pilot light is included. Possibility of replacing control
board by a wireless control with identical fonctions.
4.2.8.5. Bravo 180S Electrical Distributor
It has the same fonctions as System 3’s, it includes a flowmeter in the distributor and a controlling computer in control
board. For more automatized and informative processes, a GPS aerial will have to be assembled for speed control, and a
pressure sensor in the distributor to inform about working pression and a level sensor in the tank to obtain information at
every moment about the remaining liquid volume in the tank.
4.2.8.6. Sonar MCK Electrical Distributor
Electrical distributor with monitoring computer which allows to open independently right and left sectors which are
controlled by an active sonar. This distributor includes hand-operated pressure regulation.
4.2.9. Can Rinsing
It is used to rinse the used can once it has been emptied, sparing mostly all the product and avoiding damages in the
environment. It is placed in the filling mouth of the tank. It is triggered by a valve of the pressure collector.
4.2.10. Mixer/ chemical inductor (In option)
Located at the side of the tank, with the only difference that the one of the upper lid has not draining valve. It only helps
to transfer product in liquid or powder to the tank mixing it with water. A can rinsing device is set up with a flow stirring
system which causes the mixture of phytosanitary product with the water of main tank and a ventouri system in the tank
to empty the mixer.