Teyme ASM1-200-24, Instructions Manual

Page: 25 / 46

Mistblowers Notice of Instructions
Page 24 of 43
5.5. Water Circuit
5.5.1. Suction Filter
Check that the suction as well as the pressure filters are closed, contain the filtering cartridges and these are clean and
complete.
The filter will be able to be replaced or cleaned, depending on necessity, unthreading directly the lid. The filters-bearer has
a system which closes in the circuit the water which comes from the tank preventing this from overflowing in case the
tank would have liquid. Check the o’ring joint before assembling again the lid and replacing it if this is damaged.
ATTENTION! For a better watertighness of the lid and the o’ring joint, moist with grease all the area which fits the
lid. Any small leakage or suction of air will have to be repaired.
5.5.2. Piston Pump
On no account this sort of pump should work in dry for more than 30 seconds. If that was the case, the pistons will finish
burned and would have to be replaced.
Before starting, check the oil level of the pump. It must be between the highest and lowest level of the rod which is placed
in the upper part of the pump.
5.5.3. Diaphragm Pump
Before starting, check the oil level. It must be between the highest and lowest level of the vase placed in the upper part of
the pump
/
Level
ATTENTION! For further instructions or more specific information, check the notice of instructions of the pump
handed in with the machine.
5.5.4. Air Tank
The air tank included in the pumps it is adjusted according to default factory conditions to a pressure of 72,52-101,53 psi
to cover spraying pressure from 145,04 to 290,08 psi.
Depending on the pressure with which we are going to work, the pressure of the air tank will have to be changed
accordingly to what it is indicated in the following board: