Mistblowers Notice of Instructions
Page
28
of
43
6.1.5.
Filling of the sanitary Water Tank
The sanitary water tank is placed in the right upper part of the main tank or in the left side of the air unit. It is used to
clean hands, gloves, nozzles, etc. after having been in contact with the chemical product.
CAUTION! Even though this tank can only be filled up with clean water, this one cannot be drunk.
6.2.
Emptying Valve
The emptying valve is found in the front low part of the machine.
To empty the tank, the handle of the ball valve will have to be turned in paralled position to the exit of flow. To fill in anew
the tank, close the valve.
CAUTION! When opening the valve be careful that the liquid does not spill your hands or your feet.
6.3.
Introduction of phyto-sanitary product
There are different systems to introduce the product in the tank. The next steps must be followed:
a)
The tank must be filled in at 1/3 of its capacity with clean water before including the chemical product.
b)
Activate the pump, automatically the stirring system will start. Check visually from the access hole to the tank
that the system works correctly.
c)
If your machine has no chemical inductor available, empty directly the liquid products inside the tank.
d)
If your machine has no powder mixer available, et is convenable to dissolve previously the solid products in a can
exclusively for this usage before introducing it to the tank.
DANGER!
Follow always the instructions which appear in the label of the product.
6.3.1.
Chemical Inductor/ Mixer (Opcional)
1)
Open the lid of the tank and include the product in liquid or powder with all the circuit valves closed.
2)
Close the lid and open the mixing valve (A) caring that the mixer tank is not full.
3)
Open the discharge-can-rinsing valve (B) and the draining valve (C) located in the lower part of the tank.
4)
Valves must be opening and closing until the mixer tank remains empty and without traces of product.
5)
The can will be cleaned introducing this one upside down and getting the opening of the can inside the T-shaped
system of can rinsing inside the mixer tank and pushing the legs of the T to the can, with valves (B) and (C) open.
Can Rinsing
6.3.2.
Powder Mixer
1)
Introduce the powder directly in the basket with grid located in one of the lids of the main tank.
2)
Open the valve of the powder mixer located in one of the pump’s exits or in the distributor.
3)
Once all the powder is dissolved, close the valve.
Summary of Contents for ASM1-200-24
