12
Stand
To stand the scope upright, push the legs back
under the casing as shown below.
1-3-2. Power Up
Requirements
The DCS-1000B accepts line voltages of 100 ~
240V at 50 or 60Hz.
Step
1. Connect the power cord to
the rear panel socket.
2. Press the POWER key.
The display becomes
active in ~ 30 seconds.
: ON
: OFF
POWER
Note
The DCS-1000B recovers the state right before the
power is turned OFF. The default settings can be
recovered by pressing the Default key on the front
panel. For details, see page 141.
1-3-3. First Time Use
Background
This section describes how to connect a signal,
adjust the scale, and compensate the probe.
Before operating the DCS-1000B in a new
environment, run these steps to make sure the
instrument performs at its full potential.
1. Power On
Follow the procedures on the previous page.
2. Firmware
Update to the latest firmware.
Page 168
3. Optional
appliction
Add the Optional application,
depending on the necessity.
Page 118
4. Reset System Reset the system by recalling the
factory settings. Press the
Default
key
on the front panel. For details, see
page 141.
Default
