81
2. Press the
Bus
key.
BUS
B
3. Press
Bus
from the bottom menu
and choose the
CAN
serial bus.
Define Inputs
1. Press
Define Inputs
from the lower
menu.
2. From the side menu choose the
CAN Input
inputs and the signal
type.
CAN Input
CH1 ~ CH4
Signal Type CAN_H, CAN_L, Tx, Rx.
Note
The
Sample Point
soft-key indicates the sampling
position of each bit. This parameter is fixed.
Bit Rate
The
Bit Rate
menu sets the bit rate of the bus. The
bit rate is usually tied to the bus length.
3. Press
Bit Rate
from the bottom
menu and set the bit rate.
Bit Rate
10kbps, 20kbps, 50kbps, 125kbps,
250kbps, 500kbps, 800kbps, 1Mbps
3-6-2-6. LIN Serial Bus Interface
The local interconnect network (LIN) bus is a single wire interface.
Panel operation 1. Connect the bus signal (
LIN Input)
to one of the
channel inputs. Connect the ground potential of
the bus to the probe’s ground clip.
LIN
CAN Input
X10
X1
2. Press the
Bus
key.
BUS
B
3. Press
Bus
from the bottom menu
and choose the
LIN
serial bus.
Define Inputs
1. Press
Define Inputs
from the lower
menu.
