Texas Instruments MSP50C6xx, User Manual

Page: 68 / 390

I/O
3-4
The following table shows the bit locations of the I/O port mapping:
(8-bit wide location)
07 06 05 04 03 02 01 00
A port data register address 0x00 . . . . . A7 A6 A5 A4 A3 A2 A1 A0
A port control register address 0x04 . . . C C C C C C C C
B port data register address 0x08 . . . . . B7 B6 B5 B4 B3 B2 B1 B0
B port control register address 0x0C . . . C C C C C C C C
C port data register address 0x10 . . . . . C7 C6 C5 C4 C3 C2 C1 C0
C port control register address 0x14 . . . C C C C C C C C
D port data register address 0x18 . . . . . D7 D6 D5 D4 D3 D2 D1 D0
D port control register
†
address 0x1C . . C C C C C C C C
E port data register address 0x20 . . . . . E7 E6 E5 E4 E3 E2 E1 E0
E port control register address 0x24 . . . C C C C C C C C
A7, B7, C7, D7, E7 : data register
C : control register (0 = IN, 1 = OUT)
0x00 : state of control register after RESET low
† Ports D4 and D5 may be dedicated to the Comparator function, if the Comparator Enable bit is
set. If so, then bits 4 and 5 of the D port Control register must be CLEAR. Please refer to Section
3.3, Comparator, for details.
Port D
0
is connected to the branch condition COND1. Port D
1
is connected to
the branch condition COND2, assuming the comparator is disabled. Please
refer to Section 3.1.4, Branch on D Port, (and to Section 3.3, Comparator) for
more information. External interrupts can be detected when transitions occur
on ports D
2
, D
3
, D
4
, and D
5
. The interrupts associated with the D port are
supported whether those pins are programmed as inputs or as outputs.
3.1.2 Dedicated Input Port F
Port F is an 8-bit wide input-only port. The data presented to the input pin can
be read by referring to the appropriate bit in the F port data register, address
0x28. This is done using the IN instruction, with the 0x28 address as an
argument. The state of the F port data registers is not initialized with RESET.
After RESET is taken high, the state of the F port data register is unknown.
Each of the pins at port F has a programmable pull-up resistor. All eight pullup
resistors can be enabled by setting the enable pullup (EP) in the interrupt/gen-
eral control register (IntGenCtrl). The address of the IntGenCtrl is 0x38, and
the location of the EP bit is 12. Clearing the EP bit disables the eight pullups,