![background image](http://html.mh-extra.com/html/tesa/05330210/05330210_instruction-manual_1090539037.webp)
Instruction Manual for TESA CLINOBEVEL 3
37
On the display, the control panel of the TESA
CLINOBEVEL 3 is sketched with its keys and LEDs. If
any key on the control panel or the key on the infrared
remote control is pressed, the real LEDs as well as
those on the display will lit. In addition, the key pressed
will be marked. Each key will create an individual
pattern. Thereby the real LEDs and those on the display
must be identical. If this is not the case, either a key or a
LED is defective.
After 10 seconds without activating any key the instrument will leave the function check mode.
The measuring instrument returns to the measuring mode.
9 READING OUT MEASURIEMENT DATA WITH THE HYPERTERMINAL
1.
Open your terminal program
2. Enter the COM port connected to the TESA CLINOBEVEL 3.
3.
Enter the parameters
Bits per Second: 9600
Data bits: 7
Parity: none
Stopbits: 2
Protocol: none
4.
Repeatedly pressing the key
on the TESA CLINOBEVEL 3, the actual value will be transmitted in
[Rad].
Alternatively it can be called from the terminal program by sending the ASCII value "
P
” to the instrument.
10 ERROR MESSAGE
After the start of the instrument the TESA CLINOBEVEL 3 performs a function check. If any errors are detected, the
instrument must be returned to the TESA reseller
. A proper functioning cannot be guaranteed. The following error
messages may appear:
Display is blinking grey mottled.
Programme memory is defective
Display blinks two times grey mottled
Display error
ERROR 1
General instrument defect
ERROR 2
No calibration data available
ERROR 3
Sensor not found
ERROR 4
Wireless module not found
ERROR 5
Defective flash memory
ERROR 6
Defective EEPROM