![background image](http://html.mh-extra.com/html/tesa/05330210/05330210_instruction-manual_1090539025.webp)
Instruction Manual for TESA CLINOBEVEL 3
25
The
value
displayed
is “0”
and represents the position of
the reference defined.
The values stored in the registers "
ZERO
" and/or "
Rel
Zero
" can be changed or deleted as
follows:
Select with the key
the function [REL ZERO] or [ABS ZERO] and
confirm this selection with
. Press now again the key
. The offset value stored will be displayed. Press now the keys
until the display shows the desired value. Using the key
, the value
can directly be set to "0". With the key
the value displayed will be
stored and the procedure terminated. With the key
the procedure will
be abandoned without change. After that the TESA CLINOBEVEL 3 will return to the
measuring mode.
Use this procedure if you have to set one of these registers to an exact value, e.g. 5°.
7.9 Measurement
with Limits /
LIMITS
If you intend to set off an “Alarm” when a defined limit is exceeded this can be realised using
the function “LIMITS”.
The function “LIMITS” allows defining an upper and a lower
limit
. If this set limit is exceeded
respectively under-run, a horizontal bar in the display will start blinking. A blinking bar above
the displayed value means that the upper limit has been exceeded. If the blinking bar is below
the lower limit has been under-passed. Through the RS485 port a message will be sent.
Using the key
select the menu point [LIMITS] and confirm your selection with
.
Switch the function [LIMITS] on using the keys
and confirm with the key
.
You can now enter the lower limit. The value is adjusted
with the keys
. Confirm your entry
with the key
. With the key
the default value will be recalled.
OF F
Limits
000.00
Lower Limit
mm/m
+