Instruction Manual for TESA CLINOBEVEL 3
21
7.3 Selection of the
measuring unit /
UNIT
You can change the measuring unit of the inclination values displayed. If you start the function
[UNIT] the list of the available measuring units will appear. With the keys
you can now select the preferred measuring unit. For memorizing the measuring unit selected
you press now the key
. The measuring unit will remain active until you
change it again according to the above procedure.
The following
measuring units
can be chosen.
xxxx.xx
mm/m
mm per m / 2 decimals
xxx.xxx
mm/m
mm per m / 3 decimals *
xx.xxxx
"/10"
inch per 10 inches / 4 decimals
xx.xxxx
"/12"
inch per 12 inches / 4 decimals
xxxx.xx
mRad
Milliradian / 2 decimals
xxxx.xx
mm/REL
mm in relation to the relative base / 2 decimals
xxx.xxx
mm/REL
mm in relation to the relative base / 3 decimals*
xx.xxxx
"/REL
inches in relation to the relative base /
4 decimals
xxxx.xx
A %
o
artillerie-permille
xxxx.xx
%
o
permille
xxx.xxx°
DEG
degrees / 3 decimals
xxx° xx'
DEG
degrees / minutes
xx° xx' xx"
DEG
degrees / minutes / seconds
xxxx' xx"
DEG
minutes / seconds
xxxxxx"
DEG
seconds
xxxxx.x"
DEG
seconds*
xxx.xxx
GON
Gon / 3 decimals
7.4 Units with relative
base length
The units mm/REL and "/REL are related to a relative, this means selectable, base length.
After selecting one of these units, the relative base length must be entered.
Example:
mm/REL /
mm in relation to a relative base /
2 decimals.
After the selection of the measuring unit in our example the
stored base length of 1000 mm will appear.
With the keys
the proposed base
length can be modified. The newly entered value can finally
be confirmed with the key
. With the key
the default value 1000 mm will be
recalled.
The following measurements are now related to a base
length of 1250 mm.
When measuring in the "relative zero” mode, the height
"
X
" will be displayed as linear measure in the selected
unit and in relation to the set base length (in
mm
or
inches
).
1000
Unit
mm/REL
1250
Unit
mm/REL