Page
15
of
76
To put the clamp back in position:
Make sure that the high part of the inner black piece
is pointing towards the front, on a 20° angle, as
shown in this top view.
Under an angle of 20°, put the clamp head back in
position.
Without forcing, the clamp should slide completely
down, as shown in the picture.
If this doesn’t work the first time, make sure that
both the inner black piece and the clamp head are
under an angle of 20°. Then, try inserting again.
Without forcing, rotate the clamp head 20°
clockwise.
If the clamp head points exactly towards the front
of the device, the position is correct. The device can
be switched-on again.
WARNINGS
•
Always switch off the device before performing the clamp emergency exit.
•
The clamp must be put back in place before supplying power to the device.
•
At the moment of locking the clamp:
•
Make sure that the tube is inserted completely to the back of the clamp.
•
Make sure that the tube is not bent. It needs to be straight.
•
After locking the clamp, always make sure that the tube is correctly locked inside the
clamp. It must be possible to move the tube from left to right and it must be impossible
to take the tube out of the clamp. If the tube is stuck in any way:
1.
Open the clamp by pressing
‘Open clamp’ and ‘Yes’.
2.
Insert the tube correctly.
3.
Lock the clamp again.
4.
Recheck that the tube is correctly locked.
•
Do not insert sharp objects in the clamp.
Summary of Contents for T-RAC II
